Tab and Slot design methods - race-deZert

When I have multiple instances of a part in an assembly and I go in to configure a Tab & Slot feature on one of them The Tab gets copied

slot terminating short of the cover and providing a tab foldable over the outer side of the said wall and tend- ing to remain in the plane of the flap

taberna de los muertos slot I am having an issue with the tabs bar not showing on a device when using slot=“bottom” If I switch the slot to top everything shows

tab and slot Assuming the tab is flush with the outside surface of the slot, I would classify it as a square groove Two arrows would be required to weld