Japanese Fret Slot Saw 120mm Length Width

A slot width of 023 is recommended for this fret wire, but somewhat wider may work if you use glue to set the frets in Be sure to measure the width, height

Japanese Fret Slot Saw 120mm Length Width It's hard to tell from the picture, but I'm guessing you're around 132 wide on the slot That's ~ 031, and the blades for fret slotting are

A slot width of 023 is recommended for this fret wire, but somewhat wider may work if you use glue to set the frets in Be sure to measure the width, height

the dog house free slot Typical fret wire has a tang width Rounding to allows a max tolerance of 12 tang width OK for me; don't know about you

fret slots So naturally I did this 024 end mill Do you have a way to accurately and precisely measure the width of your cuts?

fret slot saw It all starts with the fret slots They must be cut precisely and have a uniform width along their entire length You can cut them by hand (see my fret saw

Our fretwire is sized to fit a fret slot width Fretwire is made in a variety of crown heights Note that after the frets are installed and